Universal Remote DMS-100 Specifikace stáhnout pdf (Strana 105)

Ringing in Series II peripherals 3-37

DMS-100 Ringing System

46 To test the LCM units, type

> POST LCM 0 0

and press the Enter key.

> TST UNIT 0

and press the Enter key.

> POST LCM 0 1

and press the Enter key.

> TST UNIT 0

and press the Enter key.

Note:

This step tests the ringing generators.

47 You completed this procedure.

Single LCM conﬁguration

This procedure describes how to reconﬁgure the ringing generators in

peripheral modules (PM) in a single LCM conﬁguration. The procedure begins

with the reconﬁguration of ringing generator 1 and then reconﬁgures ringing

generator 0. For the following procedure, the LCM site is RLCM. The frame

number is 0. The unit number for the LCM is 0. These values are for example

only. Operating company personnel should use site, frame, and unit values for

the affected single LCM PMs.

Perform this procedure during a period of low trafﬁc. In the unlikely event that

something happens and obstructs the ringing system, back out of the procedure

by reversing the steps you entered. If a serious problem exists, such as an E1

outage, immediately contact Emergency Technical Assistance Support

(ETAS).

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 133 134

Žádné komentáře

Universal Remote DMS-100 Specifikace Strana 105