Universal Remote MRF-350 Instalační manuál

MRF-260 Installation ManualOptimizing Narrow Band Receptionwith Complete Control RemotesCOMPLETE™Universal R emote Control®CONTROLC OMPL E TE

MRF-260 BASE STATIONPage 7Controlling Four Identical Components/Zones There are several considerations to take into account when you areinstalling an

MRF-260 BASE STATIONPage 8By looking at the Signal column, you can see that the factorydefault programming sets all of the devices to send both IR and

Page 9MRF-260 BASE STATIONIn the figure below, each device is set to a specific flasher.Note: Remember, the MRF-260 will only respond to selections 1t

MRF-260 BASE STATIONPage 10Programming For Multiple Equipment LocationsYou can operate up to 15 different equipment locations, each withan MRF-260 ass

MRF-260 BASE STATIONPage 11USA Limited Warranty StatementYour Universal Remote Control, when delivered to you in newcondition, is warranted against de

MRF-260 BASE STATIONPage 12Frequently Asked QuestionsCan I use flasher/emitters that I have already installed in the sys-tem to connect to the MRF-260

500 Mamaroneck Avenue, Harrison, NY 10528 Phone: (914) 835-4484 Fax: (914) 835-4532 www.universalremote.comThis equipment has been tested and found to

MRF-260 Installation Manual ©2007 Universal Remote Control, Inc.The information in this manual is copyright protected. No part of this man-ual may be

TABLE OF CONTENTSIntroduction 1Features and Benefits 2Parts Guide 2Installation 3Testing 5Front Blaster Overload 6Disabling the Front Blaster - Step b

Page 1MRF-260 BASE STATIONIntroductionThe MRF-260 base station is an “addressable” base station. RFAddressing gives you the ability to control as man

Page 2MRF-260 BASE STATIONFeatures and BenefitsInterference Rejection and Extended Range via Narrow BandThe MRF-260 receives RF (radio frequency) sign

Page 3Installation1. Unplug the MRF-260. Test all IR commands and macros line ofsight. 2. Power on all AV components including the TV. Turn on all of

Page 45. Observe the Status LED of the MRF-260. If it is glowing or flick-ering you must relocate the MRF-260 to a location where theLED doesn’t flick

MRF-260 BASE STATIONPage 5TestingTest a few commands for each device before fixing the flasher inplace on the front panel of a device.Since TiVo, Repl

MRF-260 BASE STATIONPage 6Front Blaster OverloadA few models of audio/video components can be overloaded by theFront Blaster. If you are having interm